| Re: Cutting Carbon Handlebars
This should help:
http://www.eastonbike.com/downloadab...-05-Carbon.pdf
It seems to be a rather complicated process.. hopefully you can pull it off
properly. A paranoid thing I could probably picture myself doing would be
mixing up some Epoxy after the bars were cut, and giving the cut ends of the
bar a coat of Epoxy inside and out to stop fraying or something, incase that
happened.
Mike
http://mikebeauchamp.com
"Ron and Arlene Palmer" <ronpalmer@prodigy.net> wrote in message
news eFpb.24628$2d7.13797@newssvr31.news.prodigy. com...
> Hello,
> I need to cut an inch or so from either end of a carbon mtb handle. Is
> there anyone who might be able to share a cutting method with me? I'm
> thinking about using a fine-tooth hacksaw blade after placing masking tape
> down to mark the area to be cut. Is there a better/more propriate method
> out there?
> Thank you!!
> Regards, Ron
>
>
>
|